CHECK INPUT VOLTAGE OF STARTER RELAY.

1) Turn the ignition switch to OFF.

2) Remove the starter relay.

3) Connect the connector to ignition switch.

4) Measure the voltage between starter relay connector and chassis ground after turning the ignition switch to START position.

Connector & terminal

LHD model

(B225) No. 9 (+) — Chassis ground (−):
(B225) No. 11 (+) — Chassis ground (−):

RHD model

(B225) No. 24 (+) — Chassis ground (−):
(B225) No. 22 (+) — Chassis ground (−):

QUESTION
Is the voltage 10 V or more?
Yes	No
	Check the following item and repair or replace if necessary. • Blown out of fuse • Open circuit in harness between starter relay and ignition switch connector • Poor contact of ignition switch connector