| CHECK HARNESS BETWEEN ECM AND STARTER RELAY CONNECTOR. |
|
1) Turn the ignition to OFF. 2) Disconnect the connector from ECM. 3) Remove the starter relay. 4) Measure the resistance of harness between ECM connector and starter relay connector. Connector & terminal LHD model with push button start (B135) No. 20 — (B225) No. 9: LHD model without push button start (B135) No. 20 — (B225) No. 10: RHD model (B135) No. 20 — (B225) No. 25: |
| QUESTION | |
|
Is the resistance less than 1 Ω? | |
| Yes | No |
|
|
Repair the harness and connector. NOTE: In this case, repair the following item: • Open circuit of harness between ECM connector and starter relay connector • Poor contact of OP joint connector (RHD model) |
