| CHECK POWER SUPPLY OF CRANKSHAFT POSITION SENSOR. |
|
1) Turn the ignition switch to OFF. 2) Disconnect the connector from the crankshaft position sensor. 3) Turn the ignition switch to ON. 4) Measure the voltage between crankshaft position sensor connector and engine ground. Connector & terminal (E10) No. 3 (+) — Engine ground (−): |
| QUESTION | |
|
Is the voltage 4.5 V or more? | |
| Yes | No |
|
|
Repair the harness and connector. NOTE: In this case, repair the following item: • Open circuit in harness between ECM connector and crankshaft position sensor connector • Poor contact of ECM connector • Poor contact of coupling connector |
