CHECK HARNESS BETWEEN ECM AND STARTER RELAY CONNECTOR.

1) Turn the ignition switch to OFF.

2) Disconnect the connectors from ECM and starter relay.

3) Measure the resistance of harness between ECM and starter relay connector.

NOTE:

For AT model, place the select lever in “P” range or “N” range.

Connector & terminal

LHD model

(B136) No. 34 — (B225) No. 10:

RHD model

(B136) No. 34 — (B225) No. 25:

QUESTION

Is the resistance less than 1 Ω?

Yes No

Repair the harness and connector.

NOTE:

In this case, repair the following item:

• Open circuit of harness between ECM and starter relay connector

• Poor contact of joint connector (RHD model)