| CHECK STARTER RELAY (PUSH BUTTON START) POWER SUPPLY. |
|
1) Install the IG relay 1 (push button start). 2) Remove the starter relay (push button start). 3) Turn the ignition to ON. 4) Measure the voltage between starter relay (push button start) connector and chassis ground. Connector & terminal (B425) No. 22 (+) — Chassis ground (−): (B425) No. 24 (+) — Chassis ground (−): |
| QUESTION | |
|
Is the voltage 10 V or more? | |
| Yes | No |
|
|
Check the following item and repair or replace if necessary. • Blown-out of fuse (F/B No. 26) • Open circuit or short circuit to ground in harness between starter relay (push button start) connector and IG relay 1 (push button start) connector • Open circuit or short circuit to ground in harness between starter relay (push button start) connector and battery |
