| CHECK ROLL CONNECTOR. |
|
1) Turn the ignition switch to OFF, disconnect the battery ground cable, and wait for 20 seconds or more. 2) Disconnect the test harness N from connector (AB38). 3) Remove the instrument panel lower cover and disconnect the connector (AB7) from (AB2). 4) Connect the connector (1P) in the test harness P to connector (AB2). 5) Connect the airbag resistor to the connector (3P) of test harness P. 6) Connect the battery ground terminal and turn the ignition switch to ON. |
| QUESTION | |
|
Does the airbag warning light illuminate for 6 seconds and go off? | |
| Yes | No |
|
Replace the roll connector. |
|
