CAUTION:
Gas is colorless, odorless, and harmless. However, gas pressure may spray cutting powder or oil. Be sure to wear dust-resistant goggles.
1. Cover with a vinyl sack as shown in the figure.
|
(1) |
Rear gate damper stay |
|
(2) |
Vinyl sack |
NOTE:
Prevent the vinyl sack from being caught by drill cutting edge
2. Lift the body side slightly with piston rods fully extended, and secure the body side with vise.
Drill a hole of 2 to 3 mm (0.08 to 0.12 in) diameter at a point 10 to 200 mm (0.39 to 7.87 in) from the body side, and bleed the rear gate damper stay gas completely.
|
(1) |
Door side |
|
(2) |
Body side |
|
(3) |
190 mm (7.48 in) |
|
(4) |
10 mm (0.39 in) |
|
(5) |
Piston rod |
|
(6) |
Cylinder |
|
(7) |
Portion to be drilled |