1. Insert a plastic clip remover into the slit at the bottom edge of the center panel, and lift the panel.
2. Disengage the tabs and plastic hooks, and remove the center panel.
1. Remove the console box. 
2. Remove the shift knob. (MT model)
3. Detach the plastic hooks (A) and pull up on the console front panel.
NOTE:
Pull up towards the rear of the vehicle to remove.
4. Remove the clips and screws, and remove the console side panel.
NOTE:
Pull towards the rear of the vehicle to remove.
• Driver’s side
1. Detach the plastic hooks (A) and remove the instrument panel side cover.
2. Remove the plastic hook (A), and detach the meter visor.
NOTE:
• Pull the plastic hooks at the bottom of the meter visor towards you to remove.
• If the plastic hooks cannot be removed, perform the following procedures.
1. Remove the instrument panel lower cover.
2. Remove the lower plastic hooks of meter visor using the clip remover, etc.
3. Remove the screws and tabs to remove the ornament panel.
• Passenger’s side
1. Remove the instrument panel lower cover.
2. Remove the plastic hook (A), and detach the meter visor.
NOTE:
• Pull the plastic hooks at the bottom of the meter visor towards you to remove.
• If the plastic hooks cannot be removed, perform the following procedures.
1. Remove the instrument panel lower cover.
2. Remove the lower plastic hooks of meter visor using the clip remover, etc.
3. Insert a plastic clip remover into the slit at the bottom edge of the center panel and lift the panel.
4. Disengage the tabs and plastic hooks, and remove the center panel.
5. Detach the plastic hooks (A) and remove the instrument panel side cover.
6. Remove the glove box lid. (Manual A/C model)
7. For manual A/C model, remove the control cable.
8. Remove the screws and plastic hooks to remove the ornament panel.
9. Disconnect each connector.
1. Remove the console box.
2. Remove the center panel.
3. Remove the console front panel.
4. Remove the ornament panel on the passenger’s side.
5. Remove the instrument panel lower cover.
6. Remove the glove box lid and glove box lower cover.
7. Remove the screws and nuts to remove the instrument panel lower.
NOTE:
The screw indicated by the white arrow is installed on the reverse face.
