1. Disconnect the ground cable from battery.
2. Remove the gusset cover.
(1) Pull the gusset cover towards the rear of the vehicle by removing tabs (A) on the backside of the gusset cover.
(2) Insert a plastic remover into the position shown in the figure while retaining the condition in step (1), and pull up on the gusset cover.
(3) Remove the gusset cover in the direction of the arrow by removing the clip (B), and disconnect the connector.
3. Open the cover of the inner remote section, and remove the screws.
4. Remove the power window switch panel.
(1) Open the cover and remove the screw.
(2) Pull up on the end of the switch panel by using a plastic remover.
(3) Disengage the side tabs by using a plastic remover.
(4) Remove the power window switch panel.
5. Remove the door trim screws.
6. Remove the door trim.
(1) Remove the clips, and lift the door trim.
NOTE:
Insert a plastic remover into the slit at the bottom of the door trim and lift the door trim.
(2) Remove the cable (1) and (2) from the cable holder of inner remote.
(3) Disconnect the harness connector and remove the door trim.
1. Disconnect the ground cable from battery.
2. Remove the gusset cover.
(1) Press the gusset cover towards the front of the vehicle by removing tabs (A) on the backside of the gusset cover.
(2) Insert a plastic remover into the position shown in the figure while retaining the condition in step (1), and pull up on the gusset cover.
(3) Remove the gusset cover in the direction of the arrow by removing the clip.
3. Open the cover of the inner remote section, and remove the screws.
4. Remove the power window switch panel.
(1) Open the cover and remove the screw.
(2) Pull up on the end of the switch panel by using a plastic remover.
(3) Disengage the side tabs by using a plastic remover.
(4) Remove the power window switch panel.
5. Remove the door trim screws.
6. Remove the door trim.
(1) Remove the clips, and lift the door trim.
NOTE:
Insert a plastic remover into the slit at the bottom of the door trim and lift the door trim.
(2) Remove the cable (1) and (2) from the cable holder of inner remote.
(3) Disconnect the harness connector and remove the door trim.