CAUTION:
Before assembly, check that the routing of harnesses such as those for the side airbag and inner seat belt harnesses, and make sure to route correctly during assembly. Incorrect harness routing during assembly can result in pinched harnesses or short circuits.
1. Remove the seat from vehicle. 
2. Remove the seat lifter cover using a flat tip screwdriver and loosen the inner bolt to remove the seat lifter lever.
3. Disengage the tab on the backside while pulling the reclining lever, and remove the reclining lever cover.
4. Remove screws (A) and clips (B), and then detach the seat side cover outside.
5. Remove the bolts and remove the inner seat belt assembly.
6. Remove the screws to detach the seat side cover inside.
7. Remove the bolts on the seat cushion assembly side, and remove the slide rail.
• Driver’s seat
• Passenger’s seat
8. Remove the bolts from the right and left reclining hinges.
9. Remove the plastic fastener at the back side (bottom) of backrest.
10. Open the fastener at the rear side of backrest.
11. Remove the hog rings of backrest cover.
CAUTION:
When removing the hog rings, be careful not to tear the vinyl sheet within the seat.
If the sheet has torn, replace it with a new sheet.
12. Remove the pad (A) and then remove the mounting nuts for side airbag module.
13. Remove the headrest bushing.
NOTE:
Push outside to remove it from the inside of seat.
14. Pull out the backrest frame.
15. Remove all of the hog rings on the front side of the backrest, and then remove the backrest cover from backrest.
16. Remove the plastic hooks of the seat cushion cover, and then remove the seat cushion frame assembly.
17. Remove all the hog rings, and then remove the seat cushion cover from the seat cushion pad.
18. Open the fastener on the bottom of the headrest, then remove the headrest cover from the headrest.
CAUTION:
• Before assembly, check that the routing of harnesses such as those for the side airbag and inner seat belt harnesses, and make sure to route correctly during assembly. Incorrect harness routing during assembly can result in pinched harnesses or short circuits.
• Do not disassemble the backrest assembly, and seat cushion frame and slide rail assembly.
1. Remove the seat from vehicle.
2. Remove the power seat switch knob.
3. Disconnect the connector for reclining motor from the backside of seat cushion.
4. Remove the screw (A) and clips (B), and then disconnect the seat switch connector to remove seat side cover outside.
5. Remove the bolts and remove the inner seat belt assembly.
6. Remove the screw (A) and clip (B), and then remove the seat side cover inside.
7. Remove the two bolts from the reclining hinge on each left and right side.
8. Remove the plastic fastener at the back side (bottom) of backrest.
9. Open the fastener at the rear side of backrest.
10. Remove the hog rings of backrest cover.
CAUTION:
When removing the hog rings, be careful not to tear the vinyl sheet within the seat.
If the sheet has torn, replace it with a new sheet.
11. Remove the pad (A) and then remove the mounting nuts for side airbag module.
12. Remove the headrest bushing.
NOTE:
Push outside to remove it from the inside of seat.
13. Pull out the backrest frame.
14. Remove all of the hog rings on the front side of the backrest, and then remove the backrest cover from backrest.
15. Remove the clip (A) and straps (B) on the back of seat cushion.
16. Remove the bolts on both the left and right sides, and then remove the seat cushion frame from the slide rail assembly.
17. Remove the plastic fastener (A), and then remove the seat cushion from seat cushion frame.
18. Remove the hog rings, and then remove the seat cushion cover from the seat cushion pad.
19. Open the fastener on the bottom of the headrest, then remove the headrest cover from the headrest.