AIRBAG SYSTEM > Inspection Locations After a Collision
Replace the following parts when the airbag is deployed.
1. Driver’s airbag module
2. Passenger’s airbag module
3. Driver’s seat belt (pretensioner)
4. Lap seat belt pretensioner (KA model only)
5. Passenger’s seat belt (pretensioner)
6. Airbag control module
7. Front sub sensor (right and left)
8. Roll connector
9. Instrument panel (for integrating with passenger’s airbag module)
1. Airbag control module
2. Satellite safing sensor
3. Satellite safing sensor cover (model without rear seat center table)
4. Side airbag module (operating side seat backrest)
5. Side airbag sensor (operating side)
6. Curtain airbag module (operating side)
7. Curtain airbag sensor (operating side)
Check for the following parts, and replace the damaged parts with new parts.
1. Steering wheel and steering shaft
Check the steering shaft for mounting conditions and deflection of front and rear, upward and downward directions, and deflection of front and rear direction with tilt lever released. (After a collision, absorbing part of steering shaft may have been operated.)
2. Check the direct type connector of driver’s airbag module, curtain airbag module, pretensioner, etc. for damage, and also check each harness for pinch and connector damage. Replace the main harness as a unit if damage is found.
3. Check the seat cushion, backrest, seat rail and headrest for installing condition and play.