CAUTION:
• Do not drop or subject the pretensioner to any impact.
• Since the pretensioner and bracket are integrated as a unit, do not disassemble them.
1. Before working, turn the ignition switch to OFF, disconnect the battery ground cable, and wait for 20 seconds or more.
NOTE:
For the power seat, move the front seat all the way forward before removing the battery ground terminal.
2. Fold the backrest all the way forward, and then move the front seat all the way forward.
3. Remove the center pillar lower trim. 
4. Remove the anchor cover (A).
5. Loosen the shoulder anchor bolt (B), and then detach the shoulder anchor from center pillar.
6. Turn over the floor mat to disconnect the belt tension sensor connector.
NOTE:
For a model with lap seat belt pretensioner, disconnect the connector of the lap seat belt pretensioner.
7. Remove the bolt to remove the seat belt retractor.
• Model without lap pretensioner
• Model with lap pretensioner
8. Remove the center pillar upper trim.
9. Remove the two bolts to remove the adjustable anchor assembly.
1. Turn the ignition switch to OFF, disconnect the battery ground cable, and wait for 20 seconds or more.
NOTE:
For the power seat, remove the slide rail installing bolt before removing the battery ground.
2. Remove the slide rail installing bolt.
(1) Tilt the backrest forward, and move the seat to the full forward position.
(2) Remove the rear bolt cover at the rear end of the slide rail, and remove the two bolts.
(3) Move the seat to the rearmost position, and remove the two bolts at the front side of the slide rail.
3. Disconnect the seat belt warning light connector under the seat.
4. Remove the harness clips from the seat cushion frame.
5. Remove the bolts and remove the inner seat belt assembly.
