1. If the clutch switch does not operate properly (or if it does not stop at the specified position), replace it with a new part.
Specified position L:
2+1.5/0 mm (0.079+0.059/0 in)
2. Check the clutch switch for continuity. If continuity is not within the standard value, replace the switch.
(1) Disconnect the clutch switch connector.
(2) Measure the resistance between terminal 1 and 2 of the switch.
• Clutch switch (Cruise control)
|
Condition |
Terminal No. |
Specified resistance |
|
When clutch pedal is depressed |
No. 1 — No. 2 |
1 MΩ or more |
|
When the clutch pedal is not depressed |
No. 1 — No. 2 |
Less than 1 Ω |
• Clutch switch (Clutch start)
|
Condition |
Terminal No. |
Specified resistance |
|
When clutch pedal is depressed |
No. 1 — No. 2 |
Less than 1 Ω |
|
When the clutch pedal is not depressed |
No. 1 — No. 2 |
1 MΩ or more |
3. Make sure that engine does not start with clutch pedal not depressed. If the engine starts, adjust the clutch switch and inspect the clutch start circuit.
4. Make sure that engine starts with clutch pedal fully depressed. If the engine does not start, adjust the clutch switch and inspect the clutch start circuit.