1. Install the ball bearing to the input shaft.
NOTE:
Place the snap ring between the input shaft and ball bearing in advance. To select the appropriate snap ring, use the table in 8).
| ST1 899580100 | INSTALLER |
| ST2 399513600 | INSTALLER |
2. Install the snap ring to the input shaft.
|
(A) |
Snap ring |
3. Inspect the clearance between the snap ring and the ball bearing. 
4. Install the straight pin and oil squeeze plate to the input shaft.
|
(A) |
Straight pin |
|
(B) |
Oil squeeze plate |
5. Install the snap ring.
6. Install the oil seal to the input shaft holder.
NOTE:
Before installing the oil seal, apply grease to the lip seal section.
| ST 398507703 | DUMMY COLLAR |
7. Wrap vinyl tape around the shaft spline, and while hitting lightly by hand, insert the input shaft into the holder.
|
(A) |
Vinyl tape |
|
(B) |
Input shaft |
8. Install the snap ring to the input shaft holder.
NOTE:
Select an appropriate snap ring to make the clearance between the snap ring and bearing between 0 — 0.12 mm (0 — 0.0047 in)
| ST 398663600 | PLIERS |
|
Snap ring | |
|
Part No. |
Thickness mm (in) |
|
805168020 |
1.84 (0.0724) |
|
805168030 |
1.92 (0.0756) |
|
805168040 |
2.00 (0.0787) |
9. Install the O-ring to the input shaft holder.
|
(A) |
O-ring |
|
(B) |
Input shaft holder |