1. Clean the transmission exterior.
2. Using the TORX® bit T70, remove the drain plug, and drain the transmission gear oil completely.
3. Using the TORX® bit T70, tighten the transmission gear oil drain plug.
NOTE:
Use a new gasket.
Tightening torque:
44 N·m (4.5 kgf-m, 32.5 ft-lb) (Aluminum gasket silver)
70 N·m (7.1 kgf-m, 51.6 ft-lb) (Copper gasket brown)
70 N·m (7.1 kgf-m, 51.6 ft-lb) (Metal gasket black)
4. Remove the rear exhaust pipe and muffler.
• Non-turbo model
• Turbo model
5. Remove the heat shield cover.
6. Remove the propeller shaft.
7. Using the ST, remove the oil seal.
| ST 398527700 | PULLER ASSY |
|
(A) |
Oil seal |
8. Using the ST, install the oil seal.
| ST 498057300 | INSTALLER |
9. Install the propeller shaft.
10. Install the heat shield cover.
11. Install the rear exhaust pipe and muffler.
• Non-turbo model
• Turbo model
12. Pour in transmission gear oil and check the oil level.