1. Secure the oil pump housing with two nuts and a bolt.
Tightening torque:
42 N·m (4.3 kgf-m, 31.0 ft-lb)
|
(A) |
Oil pump housing |
2. Install the converter case assembly to the transmission case assembly. 
3. Install the reduction driven gear.
4. Install the reduction drive gear.
5. Join the transmission case and the extension case, and then install the rear vehicle speed sensor.
6. Insert the inhibitor switch and transmission harness connector to the stay.
|
(A) |
Transmission harness connectors |
|
(B) |
Inhibitor switch connector |
7. Install the ATF cooler pipe.
8. Install the oil charge pipe together with an O-ring.
9. Insert the input shaft while rotating it lightly by hand, and then check the amount of protrusion.
Normal protrusion A:
50 — 55 mm (1.97 — 2.17 in)
10. Install the torque converter clutch assembly.
11. Install the transmission assembly to the vehicle.