1. Remove the transmission assembly from vehicle body.

2. Pull out the torque converter clutch assembly.

3. Remove the input shaft.

4. Lift up the lever on the rear side of transmission harness connector, and then disconnect it from the stay.

5. Disconnect the inhibitor switch connector from the stay.

6. Disconnect the air breather hose.

7. Remove the oil charge pipe.

8. Remove the ATF inlet and outlet pipes.

9. Separate the converter case from the transmission case.

10. Remove the oil pump housing.

11. Take out the high clutch, thrust needle bearing and reverse clutch assembly.

12. Take out the high clutch hub and thrust needle bearing.

13. Take out the front sun gear and thrust needle bearing.

14. Pull out while being careful not to break the leaf spring of the 2-4 brake.

15. Remove the snap ring and thrust needle bearing.

16. Take out the retaining plate, drive plate and driven plate of the 2-4 brake.

17. Take out the thrust needle bearing, planetary gear assembly and low clutch assembly.

18. Remove the 2-4 brake seal.

19. Remove the snap ring.

20. Take out the 2-4 brake spring retainer.

21. Remove the 2-4 brake piston and 2-4 brake piston retainer while taking care not to damage them.

22. Pull out the leaf spring of the low & reverse brake while being careful not to bend it.

23. Remove the snap ring.

24. Take out the retaining plate, drive plate, driven plate and dish plate of the low & reverse brake.

25. Turn the transmission case upside down, and then take out the socket bolts while holding the one-way clutch inner race by hand.

26. Remove the spring retainer.

27. Take out the return spring.

28. Apply compressed air.

29. Take out the low & reverse brake piston.