1. Lift up the vehicle.
2. Clean the transmission exterior.
3. Remove the drain plug (ATF) to drain the ATF.
CAUTION:
Because the AFT will be very hot after driving, be very careful not be receive burns.
4. Perform replacement with a new gasket, and tighten the drain plug (ATF).
Tightening torque:
25 N·m (2.5 kgf-m, 18.4 ft-lb)
|
(A) |
Oil pan |
|
(B) |
Drain plug (ATF) |
5. Remove the rear exhaust pipe and muffler.
• Non-turbo model
• Turbo model
6. Remove the heat shield cover.
7. Remove the propeller shaft.
8. Using the ST, remove the oil seal.
| ST 398527700 | PULLER ASSY |
9. Using the ST, install the oil seal.
| ST 498057300 | INSTALLER |
10. Install the propeller shaft.
11. Install the heat shield cover.
12. Install the rear exhaust pipe and muffler.
• Non-turbo model
• Turbo model
13. Fill with ATF.
14. Bleed the air of control valve.
15. Check the level and leaks of the ATF.