1. Apply vaseline to the contact surface, and attach the selected thrust needle bearing to the end surface of the reduction drive gear.
NOTE:
Install the thrust needle bearing in the correct direction.
2. Install a new gasket.
3. Install the extension case to transmission case.
4. Tighten bolts to secure the extension case.
Tightening torque:
25 N·m (2.5 kgf-m, 18.4 ft-lb)
5. Install the rear vehicle speed sensor.
Tightening torque:
7 N·m (0.7 kgf-m, 5.2 ft-lb)
|
(A) |
Rear vehicle speed sensor |
6. Install the transmission assembly. 