AUTOMATIC TRANSMISSION(4AT) > Road Test
Road tests should be conducted to properly diagnose the condition of automatic transmission.
NOTE:
When performing the test, do not exceed the posted speed limit.
Check shifting between 1st ←→ 2nd ←→ 3rd ←→ 4th while driving on normal city streets.
Check the shock level when shifting up during normal driving.
Check kick-down for each gear. Check the shock level during kick-down at the same time.
• Check the 3rd gear engine brake when shifting down from 4th to 3rd range while driving in 4th gear of manual mode [50 — 60 km/h (31 — 37 MPH)].
• Check the 2nd gear engine brake when shifting down from 3rd to 2nd range while driving in 3rd gear of manual mode [40 — 50 km/h (25 — 31 MPH)].
• Check the 1st gear engine brake when shifting down from 2nd to 1st range while driving in 2nd gear of manual mode [20 — 30 km/h (12 — 19 MPH)].
• When the accelerator is lightly depressed while driving on a flat road in “D” range, check that rpm does not change abruptly.
• Check slip lock-up with following procedure. Subaru Select Monitor is required for judgement.
Before starting the check, make sure that no DTC is displayed using the Subaru Select Monitor. If there is a DTC, perform corrective actions according to the DTC, and reverify that the DTC has been cleared, before starting this check.
1. The check is to be performed on a flat and straight road or on a free roller.
NOTE:
• Slip lock-up will not operate when the vehicle is lifted up off of its wheels, since there is no surface resistance.
• When checking on the free roller, the driving resistance will be slightly inadequate. It will be easier to judge if the foot brake is lightly applied while performing the check.
2. Connect the Subaru Select Monitor.
3. Check the ATF temperature using the Subaru Select Monitor.
NOTE:
• Make sure that the ATF temperature is between 50 — 100°C (122 — 212°F).
• If the temperature is low, warm up the ATF by running the vehicle.
4. Start the engine, so that the lock-up duty can be read on the data display of the Subaru Select Monitor.
5. Drive the vehicle at a constant speed of 35 — 40 km/h (22 — 25 MPH).
6. Read the lock-up duty while vehicle is running.
Standard:
25 — 45%
NOTE:
• The reading may be slightly lower on a free roller.
• Slip lock-up control is not operating when the lock-up duty is 5% or less, or when the lock-up duty goes down immediately after starting to rise. In these cases, improper ATF or deterioration of the ATF may be the cause. Check the amount of ATF or replace the fluid, then recheck.
Stop the vehicle on an uphill grade of 5% or more and shift to the “P” range. Check that the vehicle does not move when the parking brake is released.
Check for noise and vibration while driving and during shifting.
Check for tight corner braking phenomenon when the vehicle is moved forward with the steering fully turned.
After the driving test, inspect for oil leaks.