1. Remove the taper roller bearing using the ST and a press.
| ST 498077000 | REMOVER |
2. Secure the case in a vise, remove the hypoid driven gear tightening bolts, and then separate the hypoid driven gear into differential case (RH) and differential case (LH).
|
(A) |
Hypoid driven gear |
|
(B) |
Differential case (RH) |
|
(C) |
Differential case (LH) |
3. Pull out the straight pin and pinion shaft, then remove the differential bevel gear, washer and differential bevel pinion.
|
(A) |
Differential case (RH) |
NOTE:
After adjusting the drive pinion backlash and tooth contact, remove and install the oil seal and O-ring.
1. Remove the O-ring.
2. Remove the oil seal.
3. Remove the split pin, and then remove the claw.
| ST 398527700 | PULLER ASSY |
|
(A) |
Claw |
|
(B) |
Split pin |
|
(C) |
Pin |
4. Attach the two claws to the outer race, and set the ST on the differential side retainer.
| ST 398527700 | PULLER ASSY |
|
(A) |
Shaft |
|
(B) |
Claw |
5. Restore the removed claws to original position, and install the pin and split pin.
6. Hold the shaft of ST to avoid detachment from the differential side retainer, and remove the bearing outer race.
| ST 398527700 | PULLER ASSY |
NOTE:
Replace the bearing inner and outer races as a single unit.
|
(A) |
Shaft |
|
(B) |
Side retainer |