1. Install the rear differential member plate to the rear differential.
|
(A) |
Rear differential member plate |
2. Set the rear differential to transmission jack.
3. Adjust the transmission jack, and insert the rear differential stud bolt into rear crossmember bushing properly.
4. After inserting the rear differential stud bolt into the rear crossmember bushing, lift up the transmission jack and align the rear differential to its attachment position.
5. Tighten a new self-locking nut temporarily to rear crossmember.
6. Install the rear differential front member with a new self-locking nut.
Tightening torque:
T1: 50 N·m (5.1 kgf-m, 36.9 ft-lb)
T2: 110 N·m (11.2 kgf-m, 81.1 ft-lb)
7. Tighten the self-locking nut.
Tightening torque:
70 N·m (7.1 kgf-m, 51.6 ft-lb)
8. Attach the ST to rear differential.
| ST 28099PA090 | OIL SEAL PROTECTOR |
9. Insert the spline shaft until the spline portion comes inside the side oil seal.
10. Remove ST from rear differential.
11. Push the housing to insert DOJ into rear differential.
12. Lower the transmission jack.
13. Installing procedure hereafter is in the reverse order of removal.
14. After installing, fill the differential carrier with gear oil up to the bottom of the filler plug hole or the oil temperature switch hole. 
15. Inspect the wheel alignment and adjust if necessary.
16. Perform reinitialization of the auto headlight beam leveler system. (model with auto headlight beam leveler)