1. Attach the cam sprocket to the camshaft.
NOTE:
Align the position using the camshaft knock pin and the stamp on the cam sprocket.
• LH
|
(A) |
Intake cam sprocket |
(B) |
Exhaust cam sprocket |
(C) |
Knock pin |
• RH
|
(A) |
Intake cam sprocket |
(B) |
Exhaust cam sprocket |
(C) |
Knock pin |
2. Attach the camshaft plate to the tip of the intake cam sprocket (RH).
|
(A) |
Knock pin |
3. Install the cam sprocket.
(1) Fasten the cam sprocket and install to the camshaft using ST.
| ST1 18355AA000 | PULLEY WRENCH |
| ST2 18334AA030 | PULLEY WRENCH PIN SET |
Tightening torque:
29.5 N·m (3.0 kgf-m, 21.8 ft-lb)
(2) Further tighten the bolts.
NOTE:
The illustration shows the intake cam sprocket (RH).
| ST1 18355AA000 | PULLEY WRENCH |
| ST2 18334AA030 | PULLEY WRENCH PIN SET |
Tightening angle:
25°±5°
4. Install the timing chain. 
5. Install the chain cover.
6. Attach the oil level gauge and oil level gauge guide to the chain cover.
7. Install the camshaft position sensor.
8. Install the vacuum pump.
9. Install the scavenger pump.
10. Install the crank pulley.
11. Install the V-belt tensioner.
12. Install the V-belts.
13. Install the catalytic converter and DPF.
14. Install the radiator.
15. Install the radiator main fan motor assembly.
16. Install the radiator sub fan motor assembly.
17. Install the air intake duct and hose.
18. Install the air intake boot.
19. Install the under cover.
20. Lower the vehicle.
21. Fill engine oil.
22. Fill engine coolant.
23. Connect the ground cable to battery.