1. Open the fuel filler lid.
2. Set the fuel saucer (A) with rubber seal (C), and insert the fuel filler pipe into hole from the inner side of apron.
3. Align the holes in fuel filler pipe neck and set the cup (B), and tighten the screws.
NOTE:
If the edges of rubber seal are folded toward inside, straighten it with a flat tip screwdriver.
4. Securely insert the fuel filler hose (A) and air vent hose (B) into the specified position, then attach the clamp or clip as shown in the figure.
Tightening torque:
2.5 N·m (0.3 kgf-m, 1.8 ft-lb)
|
(1) |
Hose |
|
(2) |
Clip or clamp |
|
(3) |
Pipe |
5. Tighten the bolts which hold fuel filler pipe bracket on the body.
Tightening torque:
7.5 N·m (0.8 kgf-m, 5.5 ft-lb)
6. Install the rear sub frame. 
7. Install the fuel filler pipe protector.
8. Lower the vehicle.
9. Install the rear wheel RH.
Tightening torque:
100 N·m (10.2 kgf-m, 73.8 ft-lb)
10. Connect the ground cable to the battery.
11. Inspect the wheel alignment and adjust if necessary.
12. Re-initialize the auto headlight beam leveler system.