1. Set the vehicle on a lift.
2. Remove the collector cover.
3. Disconnect the ground cable from battery.
4. Lift up the vehicle.
5. Drain approximately 3.0 L (3.2 US qt, 2.6 Imp qt) of coolant. 
6. Lower the vehicle.
7. Remove the intercooler.
8. Remove the center exhaust pipe.
9. Lower the vehicle.
10. Separate the turbocharger joint pipe from turbocharger.
11. Disconnect the engine coolant hose which is connected to coolant filler tank.
12. Disconnect the air control hose (A), and loosen the clamp that holds the turbocharger on the intake duct.
13. Remove the oil inlet pipe from the turbocharger.
CAUTION:
In order to prevent damaging the oil pipe on the cylinder head side, fix the section (a) shown in the figure when loosing the oil inlet pipe flare nut, and avoid the part from rotating together while loosening the nut.
14. Disconnect the engine coolant hose from the water pipe.
15. Disconnect the oil outlet hose from the oil outlet pipe.
16. Take out the turbocharger from engine compartment.
17. Remove the turbocharger stay.
|
(A) |
To cylinder head RH |
|
(B) |
To cylinder block RH |