1. Using the ST, install the front oil seal.
| ST 499587100 | OIL SEAL INSTALLER |
NOTE:
Use a new front oil seal.
2. Apply liquid gasket to the mating surfaces of oil pump.
NOTE:
Install within 5 min. after applying liquid gasket.
Liquid gasket:
THREE BOND 1217G (Part No. K0877Y0100) or equivalent
|
(A) |
O-ring |
3. Apply a coat of engine oil to the inside of front oil seal.
4. Install the oil pump to cylinder block. Be careful not to damage the front oil seal during installation.
NOTE:
• Make sure the front oil seal lip is not folded.
• Align the flat surface of oil pump’s inner rotor with crankshaft before installation.
• Use new O-rings.
• Do not forget to assemble O-rings.
5. Apply liquid gasket to the three bolts thread shown in figure. (when reusing bolts)
Liquid gasket:
THREE BOND 1324 (Part No. 004403042) or equivalent
Tightening torque:
6.4 N·m (0.7 kgf-m, 4.7 ft-lb)
6. Install the crank sprocket. 
7. Install the water pump.
8. Install the crankshaft position sensor.
9. Install the radiator.
10. Lift up the vehicle.
11. Install the under cover.
12. Lower the vehicle.
13. Connect the ground cable to battery.
14. Install the collector cover. (turbo model)