|
(1) |
Connecting rod bearing |
(5) |
Second ring |
Tightening torque:N·m (kgf-m, ft-lb) | |
|
(2) |
Connecting rod |
(6) |
Top ring |
T: |
45 (4.6, 33.2) |
|
(3) |
Connecting rod cap |
(7) |
Snap ring |
||
|
(4) |
Oil ring |
(8) |
Side mark |
||
1. Apply engine oil to the surface of the connecting rod bearings, and attach the connecting rod bearings to the connecting rods and connecting rod caps.
2. Position each connecting rod with the side with a side mark facing forward, and install it.
3. Attach the connecting rod cap, and tighten with connecting rod nut. Make sure the arrow mark on connecting rod cap facing front during installation.
NOTE:
• Each connecting rod has its own mating cap. Make sure that they are assembled correctly by checking their matching number.
• When tightening the connecting rod nuts, apply oil on the threads.
Tightening torque:
45 N·m (4.6 kgf-m, 33.2 ft-lb)
4. Install the oil ring upper rail, expander and lower rail by hand.
5. Install the second ring and top ring using piston ring expander.
NOTE:
Assemble so that the piston ring mark “R” faces the top side of the piston.