ENGINE (DIAGNOSTICS)(H4DOTC) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)

DTC P1519 STARTER SW 2 SYSTEM CIRCUIT (OFF)

DTC DETECTING CONDITION:

Immediately at fault recognition

TROUBLE SYMPTOM:

Failure of engine to start

CAUTION:

After repairing or replacing the defective part, perform the Clear Memory Mode and Inspection Mode .

WIRING DIAGRAM:

STEPCHECKYESNO

1.CHECK HARNESS BETWEEN ECM AND STARTER RELAY CONNECTOR.

1) Turn the ignition to OFF.

2) Disconnect the connectors from the ECM.

3) Remove the starter relay.

4) Measure the resistance of harness between ECM and starter relay connector.

NOTE:

For AT model, place the select lever in “P” or “N” range.

Connector & terminal

(B135) No. 13 — (B225) No. 10:

Is the resistance less than 1 Ω?

Repair the open circuit of harness between ECM and starter relay connector.

2.CHECK HARNESS BETWEEN ECM AND STARTER RELAY CONNECTOR.

1) Disconnect the connector from starter motor.

2) Measure the resistance between ECM and chassis ground.

Connector & terminal

(B135) No. 13 — Chassis ground:

Is the resistance 1 MΩ or more?

Repair the poor contact of the ECM connector.

Repair the short circuit to ground in harness between ECM and starter relay connector.