ENGINE (DIAGNOSTICS)(H4SO) > Basic Diagnostic Procedure

PROCEDURE

1. ENGINE

STEPCHECKYESNO

1.CHECK ENGINE START FAILURE.

1) Ask the customer when and how the trouble occurred using the interview check list.

2) Start the engine.

Does the engine start?

Inspection using “Diagnostics for Engine Start Failure”.

2.CHECK ILLUMINATION OF MALFUNCTION INDICATOR LIGHT.

Does the malfunction indicator light illuminate?

Inspection using “General Diagnostic Table”.

3.CHECK COMMUNICATION STATUS.

1) Turn the ignition switch to OFF.

2) Connect the Subaru Select Monitor or general scan tool to data link connector.

3) Turn the ignition switch to ON, and run the Subaru Select Monitor or general scan tool.

NOTE:

• Subaru Select Monitor

For detailed procedures, refer to “Subaru Select Monitor”.

• General scan tool

For detailed operation procedures, refer to the general scan tool operation manual.

Does Subaru select monitor or general scan tool communicate with vehicle normally?

4.CHECK DTC.

Read DTC using Subaru Select Monitor or general scan tool.

NOTE:

• Subaru Select Monitor

Refer to “Read Diagnostic Trouble Code” for detailed operation procedure.

• General scan tool

For detailed operation procedures, refer to the general scan tool operation manual.

Is DTC displayed on the Subaru Select Monitor or general scan tool?

Record the DTC. Repair the trouble cause.

Repair the related parts.

NOTE:

If DTC is not shown on display although the malfunction indicator light illuminates, perform the diagnosis of malfunction indicator light circuit or combination meter.

5.PERFORM DIAGNOSIS.

1) Perform the Clear Memory Mode.

2) Perform the Inspection Mode.

Is DTC displayed on the Subaru Select Monitor or general scan tool?

Inspect using “Diagnostic Procedure with Diagnostic Trouble Code (DTC)”.

Finish the diagnosis.