1.CHECK LAN SYSTEM.
Perform the diagnosis for LAN system. 
|
Is there any fault in LAN system?
|
Perform the diagnosis according to DTC for LAN system.
|
|
2.CHECK REVERSE SIGNAL USING SUBARU SELECT MONITOR.
1) Select {Current Data Display & Save} in Subaru Select Monitor.
2) Read the display of the reverse signal.
|
Is OFF displayed when the shift position is in a position other than reverse, and ON when it is placed in reverse?
|
|
|
3.CHECK LIGHTING OF BACK-UP LIGHT.
1) Turn the ignition switch to ON.
2) Set the shift lever to the reverse position.
|
Does the back-up light illuminate?
|
|
Repair the back-up light circuit.
|
4.CHECK HARNESS BETWEEN BODY INTEGRATED UNIT AND BACK-UP LIGHT SWITCH.
1) Turn the ignition switch to OFF.
2) Disconnect the connector from the body integrated unit and the back-up light switch.
3) Measure the resistance of the harness between the body integrated unit and back-up switch connector.
Connector & terminal
Gasoline non-turbo model, Diesel engine model
(B280) No. 18 — (B24) No. 1:
Gasoline turbo model
(B280) No. 18 — (T13) No. 2:
|
Is the resistance less than 0.5 Ω?
|
Replace the back-up light switch.
|
Repair the harness between the body integrated unit and back-up light switch connector.
|
5.CHECK VDCCM&H/U.
1) Connect all connectors.
2) Clear the memory.
3) Perform the Inspection Mode.
|
Is the same DTC displayed?
|
Replace the VDCCM only.
|
|
6.CHECK OTHER DTC DETECTION.
|
Is any other DTC displayed?
|
Perform the diagnosis according to DTC.
|
Temporary poor contact occurs.
|
