CHECK POWER SUPPLY CIRCUIT FOR IGNITION COIL AND IGNITOR ASSEMBLY.

1) Turn the ignition switch to OFF.

2) Disconnect the connector from the ignition coil & ignitor assembly.

3) Turn the ignition switch to ON.

4) Measure the power supply voltage between ignition coil and ignitor assembly connector and engine ground.

Connector & terminal

(E31) No. 3 (+) — Engine ground (−):

(E32) No. 3 (+) — Engine ground (−):

(E33) No. 3 (+) — Engine ground (−):

(E34) No. 3 (+) — Engine ground (−):

QUESTION

Is the voltage 10 V or more?

Yes No

Repair the harness and connector.

NOTE:

In this case, repair the following item:

• Open circuit of harness between the ignition coil and ignitor assembly, and main relay 2 connector

• Poor contact of coupling connector