| CHECK HARNESS BETWEEN ECM AND TUMBLE GENERATOR VALVE POSITION SENSOR CONNECTOR. |
|
1) Turn the ignition switch to OFF. 2) Disconnect the connector from tumble generator valve position sensor. 3) Turn the ignition switch to ON. 4) Measure the voltage between tumble generator valve position sensor connector and engine ground. Connector & terminal (E54) No. 1 (+) — Engine ground (−): |
| QUESTION | |
|
Is the voltage 4.5 V or more? | |
| Yes | No |
|
|
Repair the harness and connector. NOTE: In this case, repair the following item: • Open circuit of harness between tumble generator valve position sensor and ECM connector • Poor contact of tumble generator valve position sensor connector • Poor contact in ECM connector • Poor contact of coupling connector |
