CHECK OUTPUT SIGNAL FROM TCM USING SUBARU SELECT MONITOR.

1) Connect the connectors to TCM and transmission.

2) Connect the Subaru Select Monitor to the data link connector.

3) Start the engine, and turn the Subaru Select Monitor power switch to ON.

4) Warm-up the transmission until the ATF temperature exceeds approximately 80°C (176°F).

NOTE:

If the ambient temperature falls below 0°C (32°F), drive the vehicle until the ATF reaches its operating temperature.

5) Stop the engine and turn the ignition switch to ON (with engine OFF).

6) Shift the select lever to “P” or “N” range, and depress the accelerator pedal.

7) Read the data of low clutch duty solenoid using Subaru Select Monitor.

Low clutch duty solenoid is indicated in “%”.