| CHECK ROLL CONNECTOR. |
|
1) Turn the ignition switch to OFF, disconnect the battery ground cable, and wait for 20 seconds or more. 2) Disconnect the test harness N from connector (AB2). 3) Remove the instrument panel lower cover, and disconnect the connector (AB21) from (AB26). 4) Connect the connector (1F) in the test harness F to the connector (AB21). 5) Connect the airbag resistor to the connector (3F) of test harness F. 6) Connect the battery ground terminal and turn the ignition switch to ON. |
| QUESTION | |
|
Does the airbag warning light illuminate for 6 seconds then turn off? | |
| Yes | No |
|
Replace the roll connector. |
|
