1. Align the cutout portion at the serrated section of the steering shaft and yoke, then insert the universal joint into the steering shaft.
|
(1) |
Cutout portion |
|
(2) |
Yoke |
|
(3) |
Steering shaft |
|
(4) |
Steering shaft side |
|
(5) |
Gearbox side |
2. Match the alignment marks, and insert the universal joint into the serrations of gearbox assembly.
3. Tighten the bolt.
Tightening torque:
24 N·m (2.4 kgf-m, 17.7 ft-lb)
CAUTION:
Do not excessively tighten the torque on the universal joint bolts. Overtightening will make the steering wheel heavy.
Standard clearance between gearbox to DOJ:
14 mm (0.55 in) or more
4. Align the center position of the roll connector.
5. Install the steering wheel and airbag module.
WARNING:
Always refer to “Airbag System” before performing service on the airbag modules.