1. Clean the transmission exterior.
2. Using the TORX ® BIT T70, remove the drain plug, and drain the transmission gear oil completely.
3. Using the TORX ® BIT T70, tighten the transmission gear oil drain plug.
NOTE:
Use a new gasket.
Tightening torque:
44 N·m (4.5 kgf-m, 33 ft-lb) (Aluminum gasket)
70 N·m (7.1 kgf-m, 52 ft-lb) (Copper gasket)
|
(A) |
Drain plug |
|
(B) |
Gasket |
4. Remove the rear exhaust pipe and muffler.
5. Remove the propeller shaft. 
6. Using the ST, remove the oil seal.
| ST 398527700 | PULLER ASSY |
|
(A) |
Oil seal |
7. Using the ST, install the oil seal.
| ST 498057300 | INSTALLER |
8. Install the propeller shaft.
9. Install the rear exhaust pipe and muffler.
10. Pour in gear oil and check the oil level.