1. Pass the transmission harness assembly through the hole in transmission case.
2. Connect the control valve connector and the grounding cable.
Tightening torque:
8 N·m (0.8 kgf-m, 5.8 ft-lb)
|
(A) |
Transmission ground cable |
|
(B) |
Control valve connector |
3. Apply proper amount of liquid gasket to the entire oil pan mating surface.
Liquid gasket:
THREE BOND 1217B (Part No. K0877YA020) or equivalent
4. Fill the 3 holes aside from the bolt holes in the transmission case, with liquid gasket.
Liquid gasket:
THREE BOND 1217B (Part No. K0877YA020) or equivalent
5. Install the oil pan by equally tightening the bolts.
Tightening torque:
5 N·m (0.5 kgf-m, 3.6 ft-lb)
6. Install the front vehicle speed sensor and torque converter turbine speed sensor.
Tightening torque:
7 N·m (0.7 kgf-m, 5.1 ft-lb)
7. Connect the connector to the rear vehicle speed sensor.
8. Install the ATF cooler inlet and outlet pipes.
NOTE:
Use a new copper washer.
Tightening torque:
T1: 25 N·m (2.5 kgf-m, 18.1 ft-lb)
T2: 40 N·m (4.1 kgf-m, 30 ft-lb)
T3: 45 N·m (4.6 kgf-m, 33 ft-lb)
9. Install the transmission rear crossmember bolt.
Tightening torque:
70 N·m (7.1 kgf-m, 51.6 ft-lb)
10. Install the propeller shaft. 
11. Install the front, center and rear exhaust pipes, and the muffler. (Non-turbo model)
12. Install the center, rear exhaust pipes and the muffler. (Turbo model)
13. Lower the vehicle.
14. Install the transmission connector to the stay.
15. Install the pitching stopper.
16. Install the air intake chamber. (Non-turbo model)
17. Install the intercooler. (Turbo model)
18. Pour in ATF.
19. Bleed the air of control valve.
20. Check the level and leaks of the ATF.