CAUTION:
Be sure the lining surface is free from oil and grease.
1. Apply brake grease to the following locations.
Brake grease:
Brake Grease (Part No. 003602002)
• Six contact surfaces of the shoe rim and the back plate packing
• Contact surface of the shoe wave and the anchor pin
• Contact surface of the lever and strut
• Contact surface of the shoe wave and the adjuster assembly
• Contact surface of the shoe wave and the strut
• Contact surface of the lever and the shoe wave
2. Insert the primary side brake shoe into the anchor pin groove.
3. Secure the brake shoe with the shoe hold-down pin and the cup.
4. Install the plate to the anchor pin, and then assemble the primary return spring to the anchor pin.
|
(1) |
Primary return spring |
|
(2) |
Anchor pin |
|
(3) |
Plate |
|
(4) |
Primary shoe |
|
(5) |
Shoe hold-down pin and cup |
5. Install the parking brake cable to the parking brake lever.
6. Assemble the strut and adjuster, and then secure the secondary side brake shoe with the shoe hold-down pin and cup.
NOTE:
• Install the strut spring of both right and left wheels facing the front of the vehicle.
• Install the adjuster assembly with screw section on the left side.
|
(1) |
LH |
7. Install the secondary return spring and the adjusting spring.
|
(1) |
Lever |
|
(2) |
Secondary brake shoe |
|
(3) |
Strut spring |
|
(4) |
Strut |
|
(5) |
Secondary return spring |
|
(6) |
Adjuster |
|
(7) |
Hold-down cup |
|
(8) |
Adjusting spring |
8. Adjust the parking brake. 
9. Drive the vehicle to break-in the parking brake lining.
(1) Drive the vehicle at about 35 km/h (22 MPH).
(2) While holding the parking brake release button pressed, pull the parking brake lever gently.
(3) Drive the vehicle for about 200 m (0.12 mile) in this condition.
(4) Wait 5 to 10 minutes for the parking brake to cool down. Repeat this procedure once more.
(5) After breaking-in, re-adjust the parking brakes.