1. Attach the rear tone wheel to the hub, and attach the rear housing. 
2. Temporarily attach the rear ABS wheel speed sensor to the back plate.
CAUTION:
Be careful not to hit the ABS wheel speed sensor pole piece and tone wheel against adjacent metal parts during installation.
|
(1) |
Rear ABS wheel speed sensor |
3. Install the rear drive shaft to the rear housing and rear differential spindle.
4. Install the rear ABS wheel speed sensor harness to the trailing link and rear trailing link bracket.
Tightening torque:
33 N·m (3.4 kgf-m, 25 ft-lb)
|
(1) |
Rear ABS wheel speed sensor harness |
|
(2) |
Trailing link |
5. Check the clearance of the sensor. When the clearance is within standard values, tighten the ABS wheel speed sensor to the back plate at the specified torque.
If clearance is out of the standard value, readjust by using the spacer (Part No. 26755AA000).
ABS wheel speed sensor gap standard value:
0.7 — 1.2 mm (0.028 — 0.047 in)
Tightening torque:
33 N·m (3.4 kgf-m, 25 ft-lb)
NOTE:
Check the identification (mark) on the harness to make sure there is no warpage. (RH: White, LH: Yellow)
6. After confirmation of the ABS wheel speed sensor clearance, connect the connector to the ABS wheel speed sensor.
7. Connect the battery ground cable to battery.