NOTE:
When the hub is removed from the housing, replace the bearing set and oil seal.
1. Using the ST, press the new hub bolt into place.
NOTE:
• Make sure the hub bolt contacts the hub.
• Use the 12 mm (0.47 in) hole in the ST to prevent the hub bolt from tilting during installation.
| ST 927080000 | HUB STAND |
2. Remove the foreign particles (dust, rust, etc.) from the mating surfaces of hub tone wheel, and install the tone wheel to hub.
NOTE:
• Make sure the tone wheel contacts the hub.
• Be careful not to damage the tone wheel teeth.
|
(1) |
Tone wheel |
3. Clean the housing interior completely. Using ST1 and ST2, press the bearing into the housing.
| ST1 927430000 | HOUSING STAND |
| ST2 927440000 | BEARING REMOVER |
CAUTION:
• Always press the outer race when installing bearings.
• Be careful not to remove the plastic lock from the inner race when installing the bearings.
4. Using pliers, securely install the snap ring.
|
(1) |
Pliers |
5. Using the ST1 and ST2, press the outer oil seal unit until it comes in contact with snap ring.
| ST1 927430000 | HOUSING STAND |
| ST2 927460000 | OIL SEAL INSTALLER |
|
(1) |
Snap ring |
6. Invert both ST1 and housing (upside down).
7. Using ST2, press the inner oil seal into the housing until it touches the bottom.
| ST1 927430000 | HOUSING STAND |
| ST2 927460000 | OIL SEAL INSTALLER |
8. Using ST1 and ST2, press the sub seal into place.
| ST1 927430000 | HOUSING STAND |
| ST2 927460000 | OIL SEAL INSTALLER |
9. Apply sufficient grease to the oil seal lip.
Grease:
SHELL 6459N
NOTE:
If specified grease is not available, remove the bearing grease and apply Auto Rex A instead.
CAUTION:
Do not mix different types of grease.
10. Install back plate to the rear housing.
Tightening torque:
52 N·m (5.3 kgf-m, 38.3 ft-lb)
11. Using ST1 and ST2, press the bearing into the hub.
| ST1 927080000 | HUB STAND |
| ST2 927450000 | HUB INSTALLER |
|
(1) |
Back plate |