1. Install the knock sensor to the cylinder block.
NOTE:
Extraction area of knock sensor cord must be positioned at a 60° angle relative to the engine rear.
Tightening torque:
24 N·m (2.4 kgf-m, 17.7 ft-lb)
|
(A) |
Front side |
2. Connect the knock sensor connector.
3. Install the secondary air pipe LH.
NOTE:
Use a new gasket.
Tightening torque:
(A) 9 N·m (0.92 kgf-m, 6.6 ft-lb)
(B) 19 N·m (1.9 kgf-m, 14 ft-lb)
4. Install the EGR pipe.
Tightening torque:
34 N·m (3.4 kgf-m, 24.6 ft-lb)
5. Install the air intake chamber. 
6. Connect the battery ground cable to the battery.
