1. Release the fuel pressure. 
2. Disconnect the ground cable from the battery.
3. Open the fuel filler flap lid, and remove the fuel filler cap.
4. Remove the air intake duct, air cleaner case and air intake chamber.
5. Remove the generator.
6. Remove the power steering pump and power steering reservoir tank.
(1) Remove the bolts which hold the power steering pipes onto the fuel pipe protector RH.
NOTE:
Do not disconnect the power steering hose.
(2) Remove the installation bolt installing the power steering pump bracket.
(3) Disconnect the connector (A) from the power steering pump switch.
(4) Remove the power steering reservoir tank from the bracket by pulling it upward.
(5) Place the power steering pump on the right side wheel apron.
7. Remove the spark plug cords from the spark plugs by pulling the plug caps.
8. Disconnect the engine coolant hoses (A) from throttle body.
9. Disconnect the PCV hose (A) from intake manifold.
10. Disconnect the brake booster hose (B).
11. Disconnect the engine harness connector (C) from the bulkhead harness connectors.
12. Disconnect the connectors from the engine coolant temperature sensor.
13. Disconnect the knock sensor connector.
14. Disconnect the connector from crankshaft position sensor.
15. Disconnect the connector from the oil pressure switch (A).
16. Disconnect the connector from camshaft position sensor.
17. Remove the EGR pipe from intake manifold.
18. Disconnect the following connector.
(1) Front oxygen (A/F) sensor connector
(2) Rear oxygen sensor connector
(3) Engine harness connectors
19. Disconnect the fuel hoses from fuel pipe.
CAUTION:
• Be careful not to spill fuel.
• Catch the fuel from hoses using a container or cloth.
|
(A) |
Fuel delivery hose |
|
(B) |
Return hose |
|
(C) |
Evaporation hose |
20. Remove the bolts which secure intake manifold to cylinder head.
21. Remove the intake manifold.