1. Prepare the Subaru Select Monitor kit. 
2. Connect the diagnosis cable to the Subaru Select Monitor.
3. Insert the cartridge to the Subaru Select Monitor.
4. Connect the test mode connector (A) located at the lower portion of instrument panel (on the driver’s side).
5. Connect the Subaru Select Monitor to data link connector located in the lower portion of the instrument panel (on the driver’s side).
CAUTION:
Do not connect any scan tools except the Subaru Select Monitor or general scan tool.
6. Turn the ignition switch to ON (engine OFF) and Subaru Select Monitor switch to ON.
|
(A) |
Power switch |
7. On the «Main Menu» display screen, select {Each System Check} and press the [YES] key.
8. On the «System Selection Menu» display screen, select {Engine Control System} and press the [YES] key.
9. Press the [YES] key after the information of engine type has been displayed.
10. On the «Engine Diagnosis» display screen, select {System Operation Check Mode} and press the [YES] key.
11. On the «System Operation Check Mode» display screen, select {Actuator ON/OFF Operation} and press the [YES] key.
12. Select the desired compulsory actuator on the «Actuator ON/OFF Operation» display screen and press the [YES] key.
13. Pressing the [NO] key completes the compulsory operation check mode. The display will then return to the «Actuator ON/OFF Operation» screen.
• A list of the support data is shown in the following table.
|
Contents |
Display |
|
Compulsory fuel pump relay operation check |
Fuel Pump |
|
Compulsory radiator fan relay operation check |
Radiator Fan Relay |
|
Compulsory air conditioning relay operation check |
A/C Compressor Relay |
|
Compulsory purge control solenoid valve operation check |
CPC Solenoid |
|
Compulsory wastegate control solenoid valve operation check |
Wastegate control solenoid |
|
Secondary air combination valve 1 compulsory operation check |
Secondary Air Combination Valve 1 |
|
Secondary air pump relay compulsory operation check |
Secondary air pump relay |
NOTE:
• The following parts will be displayed but not functional because they are not installed on the vehicle.
|
Display |
|
EGR Solenoid Valve |
|
ASV Solenoid Valve |
|
FICD Solenoid |
|
Vent Solenoid Valve |
|
Pressure Switching Sol.1 |
|
Pressure Switching Sol.2 |
|
AAI Solenoid |
|
PCV Solenoid Valve |
|
Fuel Tank Sensor Control Valve |
|
Exhaust Bypass Valve Control Permit Flag |
|
Secondary Air Combination Valve 2 |
• For detailed operation procedure, refer to the “SUBARU SELECT MONITOR OPERATION MANUAL”.