1. How to disconnect:
(1) With the lock arm (A) pushed in, pull the connector in direction of arrow.
CAUTION:
When pulling the slide lock or disconnecting connector, be sure to hold the connector, not the harness.
2. How to connect:
Holding the connector (A), and push it in carefully until a clicking sound is heard.
CAUTION:
Be sure to insert the connector in until it is locked. Then pull it lightly to make sure that it is locked.
2. DRIVER’S AIRBAG (BETWEEN AIRBAG MAIN HARNESS AND ROLL CONNECTOR) & SIDE AIRBAG
1. How to disconnect:
(1) Push the lock arm (A).
(2) With the lock arm (A) pushed in, move the slide lock (B) in the direction of arrow.
(3) With the slide lock (B) pulled, move the lock arm (A) to its original position, and then pull in the direction of the arrow and separate the connector.
CAUTION:
When pulling the slide lock, be sure to hold the connector, not the harness.
2. How to connect:
Holding the connector, push it in securely until a clicking sound is heard.
CAUTION:
Be sure to insert the connector in until it is locked. Then pull it lightly to make sure that it is locked.
3. DRIVER’S AIRBAG MODULE AND PRETENSIONER
1. How to disconnect:
(1) Using a flat tip screwdriver, pry the push lock upward to unlock.
(2) Pull the connector to disconnect from driver’s airbag module assembly or pretensioner assembly.
2. How to connect:
Connect the connector in the reverse order of disconnecting. At this time, be sure to insert the push lock until a clicking sound is heard.
CAUTION:
• Be sure to insert the connector in until it is locked. Then pull it lightly to make sure that it is locked.
• Be sure to push the push lock in securely.
1. How to disconnect:
(1) Push the lock arm (A).
(2) With the lock arm (A) pushed in, pull the connector in direction of arrow to separate.
CAUTION:
When disconnecting the connector, be sure to hold the connector, not the harness.
2. How to connect:
Holding the connector, push it in securely until a clicking sound is heard.
CAUTION:
Be sure to insert the connector in until it is locked. Then pull it lightly to make sure that it is locked.
5. FRONT SUB SENSOR AND SIDE AIRBAG SENSOR
1. How to disconnect:
Holding outer part (A), pull it in the direction of arrow.
CAUTION:
When pulling the slide lock, be sure to hold the connector, not the harness.
2. How to connect:
Holding the connector, push it in securely until a clicking sound is heard.
CAUTION:
• Do not touch the outer side section or else the outer side (A) will move back.
• Be sure to insert the connector in until it is locked. Then pull it lightly to make sure that it is locked.
